What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by stewlevine

  1. S

    Help debricking XT8 node

    I have been disabling the wifi adapter so that it is only connected via the ethernet NIC. I thought I was doing all of the right things; I as hoping someone would see something obvious that I was missing.
  2. S

    Help debricking XT8 node

    I assume the Mini CFE Web page would be a page on 192.168.50.1 on the device I am trying to fix. I can't access anything on it in the browser using that address.
  3. S

    Help debricking XT8 node

    I can't get to 192.168.50.1 from a hardwired machine in Chrome, Firefox, or Edge on the same subnet. When I go back to DHCP on that same machine and connect back to the broader network to get onto the internet, that address resolves to one of my working nodes (the one I would eventually like to...
  4. S

    Help debricking XT8 node

    I'm try again. I have verified that this node is HW v1.0 and was manufactured in 2021 so I can use the most recent version firmware on it. I only waited 15-30 seconds before trying to upload. When I have the node in rescue mode and connected from a LAN port on the node to the ethernet port on my...
  5. S

    Help debricking XT8 node

    Yes I did. I have tried setting up the IP address of the Windows computer I am trying to flash it from in both 192.168.1.x (as manual states) and 192.168.50.x (to align with default IP address of the box) and I have tried connecting to both LAN ports (which I believe is the correct way) and the...
  6. S

    Help debricking XT8 node

    Bummer. I was hoping to find a way to revive it (which is why I was looking for a way to use rescue mode, but it does no good if I can get into rescue mode but can't connect to the node once the node is in rescue mode).
  7. S

    Help debricking XT8 node

    That is the exact set of steps I have been following. Unfortunately after completing the steps and power cycling the unit the flashing green never ends up with a stable color but instead repeats the brief white followed by flashing green pattern over and over which is why I am assuming it never...
  8. S

    Help debricking XT8 node

    I have reviewed the instructions. The only reason I am mucking with firmware restoration is because I can't get this node to get into setup mode (i.e., a solid blue LED). On the unit that won't reset, I did once perform setup and was in the process of connecting the other two units as nodes (I...
  9. S

    Help debricking XT8 node

    Maybe I am using the wrong term, but I assume when the device can't initialize (i.e., ever get past flashing green to go to blue and setup or get to any other steady state) there's a real issue. If someone has had this problem and overcome it, I'd much rather get the device working then argue...
  10. S

    Help debricking XT8 node

    Hi. I purchased off eBay a set of XT8 nodes. I went through setup and near the end I walked away and when I came back the node I had setup as the router no longer could connect to a computer (this had occurred while it was connecting to the other nodes to setup AIMesh, so I did not see an error...
See more
Back
Top
✖
OSZAR »